Refer below imageĢ.2 This Unibox contains 3 Physical interfaces, from which we have taken access of Unibox using 1st physical interface i.e. This section will contain all available “physical interfaces” that can be used, and which are present in your Unibox. For that refer below steps,Ģ.1 Navigate to Network>Interfaces>Physical Step 2 - After Creating a WAN Network Profile from above steps you will have to map the created WAN Profile to the physical interface present in Unibox. Select your connection type as Dynamic or Static, do necessary changes and then Save & Close. Refer below example for both type of connection for WAN profile. If your connection type is Static then, whatever IP you have configured in WAN Profile in unibox, you will get access of Unibox from that IP address only in your network.
#Unibox acordeon windows mac#
MAC address of Unibox can be found at Network>Interfaces > Physical Instead of router there might be anything like a firewall etc.) (We have considered here that Unibox is getting internet from a router. If your connection type is Dynamic then you will have to search WAN IP Address in your Router against the MAC address of UNIBOX. To take access of your Unibox from WAN side, you should know the WAN IP Address that you have mentioned while creating a new WAN profile network in step 1. Default traffic share is 100 percentage.Įnable the checkbox if WAN connection should masquerade the traffic Select connection Type as Static or DynamicĮnter Traffic share of WAN connection.The traffic share decides the amount of LAN traffic going through WAN port. 1.1 Navigate to Network> WAN & add a new WAN Profile here.
0 kommentar(er)
